I apologize if you receive this a second time. I made previous
attempts and it did not seem to go to the list distribution.
Wife says to get rid of stuff. This is a downsize project from more
than 25 years of collecting and hoarding and most items can't or
won't be replaced. Prices in most cases are lower than vendor sites
or are not available anywhere else.
I tried to post this early this morning and it didn't seem to get
through the system? I made a few revisions.
QUANTITIES ARE LIMITED AND MOST ITEMS WON'T OR CAN'T BE REPLACED
R-16/G-15 REMANUFACTURED ROCKER SHAFT ASSEMBLY. Assemblies are
available for Metric and SAE cylinder heads. The shaft has been hard
chromed and ground back to the original diameter. The rocker arms
have bronze bushings installed and the tips have been resurfaced. New
hardware including springs, washers, plugs and pins have been used.
There is a core charge that will be refunded when a rebuildable core
has been received. Price is $135.
65-70 TOP BOOT - Black stayfast . This is a cloth part that is very
nice. Price is $155.
1600/2000 NEW SLOTTED BRAKE ROTORS. Price is $235 per matched pair.
1600/2000 NEW PLAIN BRAKE ROTORS. Price is $215 per pair.
U-20 2000 CYLINDER HEAD - New in the original box. Price is $1840. RARE!!!
R-16 1600 CYLINDER HEAD - Aluminum non-smog head New in original
box. Price is $795. VERY RARE!!!
BRAND NEW 1600 3-MAIN CYLINDER BLOCK Never used empty block with
cosmoline in bores with new standard pistons/rings/pins. Price is
$485. Crank, bearings, timing components and gaskets are available.
REMANUFACTURED 3-MAIN SHORT BLOCK - New .020" domed pistons, new
genuine Nissan camshaft - not a regrind, new lifters, new U-20 oil
pump, new timing gears and chain, all new bearings block painted
original color and more. This was remanufactured by the original
Rising Sun Racing in Georgia. Price is $1965, Item has been stored
in a closed building since receipt from RSR.
U-20 2000 WATER PUMP - Genuine Nissan New in box. Price is $124.
R-16 1600 WATER PUMP - For 67.5 engines but can be used on early 1600
and 1500. Cast iron impeller. Made in Japan. Price is $95.
R-16 1600 Timing kit for 67.5 to 1970 engines. Includes chain, cam
gear, crank gear and tensioner. Price is $118.
R-16 1600 oil pump. This is a new genuine Nissan pump that has been
modified by using a good used roadster bottom plate to operate as
new. Price is $125.
EI DISTRIBUTOR WITH VACUUM ADVANCE FOR SU carburetor roadsters - All
electronic with vacuum advance - fits 1600 or 2000 with SU
carburetors . Far superior to points or points replacement
distributors. Non-smog advance curve with 15 degree maximum
mechanical advance at crankshaft as in original factory setup. This
distributor has been built using an original Nissan electronic
distributor and converted to suit roadsters by using parts from an
original roadster distributor and some newly manufactured
components. Has original roadster non-smog advance weights, springs
and cam plate to provide exact roadster timing curve. Includes new
cap and rotor. The original vacuum advance plate has been upgraded
with a newly fabricated bearing carrier with bearings so it is
superior to and more durable than the original Nissan part that was
prone to fail. The person in Wyoming that started making similar
distributors in quantity (mass marketing) provided a sample part
several years back. Price is $260. A model for Solex equipped
engines without vacuum advance is available. No core required.
1967.5 2000 REMANUFACTURED GAUGES - 160MPH Speedometer and 8000 RPM
Tachometer pair. These have newly reprinted dial faces and have
been precisely calibrated. Price is $625. Also available is a
complete remanufactured set suitable for 67.5 2000 that includes
Speedo, Tach, Clock, oil/temp and amp/fuel. Price is $1035. These
gauges can also be used for 67.5 1600.
68-70 NEW LEFT QUARTER PANEL (FENDER) - This is a 1970 new in factory
primer that will fit all 68 and later cars. It can also be used as a
skin for 67.5 cars. Price is $405. Prefer local pickup.
2000/1600 CLUTCH KIT - Includes: genuine Nissan 650KG pressure plate,
Japanese OEM clutch disc, throwout bearing made in Japan, pilot
bushing and 3 clutch cover dowel pins. Also fits early 510 and used
as high performance. Price is $235.
65-70 CLUTCH MASTER CYLINDER. Aftermarket type with reservoir in
correct location and adjustable pushrod. Price is $35.
67.5-70 DUAL RESERVOIR BRAKE MASTER CYLINDER - Non original but
genuine NABCO brand with correct 3/4" bore. Pushrod and metric to
SAE tubing adapters are included. No modification to existing car or
brake lines required. This is a low cost alternative to scarce and
expensive original cylinders. Price is $175. New original roadster
cylinder available at current market price. Other options available - ask.
65-67 SINGLE RESERVOIR BRAKE MASTER CYLINDER - Aftermarket cylinder
with adjustable pushrod. Correct 3/8-24 brake line
connection thread. It is necessary to replace the reservoir with
the one from the original cylinder. The brake line connection is on
the top instead of the side and will require change of the brake line
or adding a short line with adapter to connect to the original brake
line. Price is $49.
FUEL PUMP - 1600/2000 Aftermarket Assembled in USA. Price is $56.
68-70 NOS ORIGINAL NISSAN BLACK DOOR PANELS. "RARE" Still in
factory wrappers with clips. $285 per pair.
67.5-70 DOOR PILLAR CAPS. These are genuine Nissan. Price is $42 per pair.
63-69e IDLER BOX CAP - NOS NISSAN. Price is $23.99
63-70 DOOR WEATHERSTRIP - Aftermarket type with round seal. Better
than original. Price is $46 for both doors.
67.5-70 REPRODUCTION BATTERY HOLD DOWN AND TRAY. Tray is
powdercoated. This fits cars using group 24 batteries. Price is $39.
8 mm HEX NUTS - These are the nuts that have the hard to find 12mm
hex size that Nissan used for manifolds and carburetors. They are
hard to find since most hardware stores sell the 13mm hex
type. Price is $4.95 for 20 nuts.
63-67.5 NEW LOW WINDSHIELD GLASS - Fits 1500, 1600 and
2000. Aftermarket with light tint U.S. DOT approved. Price is $445.
40mm MIKUNI SOLEX CARBS - Pair of new NOS in Nissan factory
box. Can be used for U-20 or stroked pushrod engine OR?. NLA at
Nissan. Price is $795. Intake manifolds for G-15,R16,H20 and U20
engines are available.
MIKUNI CARB KITS FOR 40 AND 44 PHH CARBS - These are genuine kits and
sold in pairs. Price is $35 per pair.
68-70 U-20 2000 S-U CARBURETORS -Brand new pair (Front and rear)
never used. Price is $815. NLA from Nissan.
URETHANE COMP SWAY BAR BUSHING KIT - Suitable for 23mm or 7/8"(22.2mm) Same
as sold by Motorsports. 4 urethane pieces w/fasteners, instructions
and special grease. Price is $29 per set.
NEW COMPLETE 10 PC U-20 TIMING SET. Included are 2 new Nissan
tensioners (upper and lower), 2 new Nissan timing chain guides (upper
and lower), 4 new made in USA timing gears and 2 new USA made timing
chains. Price is $985.
U-20 Timing component set (Same as above) with Nissan 2L oil pump
Price is $1493.
U-20 10 Piece Timing component set with Nissan U-20 oil pump, Nissan
O.040" oversize flat top pistons with rings, rod bearings, main
bearings, jackshaft bearings, timing cover gaskets, pan gasket,
freeze plugs, front and rear crank seals, head gasket, manifold
gasket, valve stem seals. Price is $2390. Note: 2L oil pumps are
NLA from Nissan USA/Japan. Bearings sets are available in most sizes.
FIREWALL BRAKE BRACE - For all LHD cars with dual reservoir master
cylinders. These are the ones from the original supplier and much
better than the copies with smashed threads. Price is $23.
Questions will be answered by email.
Shipping is not included in pricing. Some items are local pickup only.
=====================================
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|