Well, the parts bin coughed up three of exactly what Stan described.
They thread cleanly into the head rest forks, but proved a bear to
thread through the seat back, then into the forks. And I still need
that fourth piece.
- Bob
Stan Chernoff wrote:
>Original headrest attaching screws for 68-70 cars have 1/4-28 NF threads, a
>#3 Phillips recess in a head similar to a pan head and also have a conical
>pointed tip for ease of assembly.
>
>There is only one mounting position on the original setup. Some people
>drop them all the way down or you could add additional threaded holes.
>
>Stan
>sans echo
>=========
>
>At 11:20 AM 4/22/2004 -0400, RWM wrote:
>
>
>>Candidate for arcane question of the day (but describes today's
>>lunchtime project):
>>
>>What's the sizing on the screws used to fix/attach headrests on the
>>'68-70 cars?
>>
>>These are the screws go through the seat back access holes, into the
>>tubes into which the headrest forks extend and are used to adjust the
>>height of the rests.
>>
>>Thanks.
>>
>>- Bob Mann, '68 2000 Solex
>>
>>
>
>
>
>
>
--
R.W. Mann & Company, Inc. >> Airline Industry Analysis
Port Washington, NY 11050 >> tel 516-944-0900, fax -7280
mailto:info@RWMann.com >> URL http://www.RWMann.com/
This e-mail is for the designated recipient only and may contain
privileged or confidential information. If you have received it
in error, please notify the above sender immediately then delete
the original e-mail. Any other use of this e-mail is prohibited.
|