Original headrest attaching screws for 68-70 cars have 1/4-28 NF threads, a
#3 Phillips recess in a head similar to a pan head and also have a conical
pointed tip for ease of assembly.
There is only one mounting position on the original setup. Some people
drop them all the way down or you could add additional threaded holes.
Stan
sans echo
=========
At 11:20 AM 4/22/2004 -0400, RWM wrote:
>Candidate for arcane question of the day (but describes today's
>lunchtime project):
>
>What's the sizing on the screws used to fix/attach headrests on the
>'68-70 cars?
>
>These are the screws go through the seat back access holes, into the
>tubes into which the headrest forks extend and are used to adjust the
>height of the rests.
>
>Thanks.
>
>- Bob Mann, '68 2000 Solex
|