I put the top on mine years ago and am planning to replace it soon. It
really isn't a bad job. Just time consuming. Just take your time. Make
sure everything lines up and is properly centered. Be sure to do it on a
very warm day so you can stretch it tight.
Best regards,
Fred Schroeder
Denison, TX
SRL311-13359
TDROC
Reg e-mail sitsinwest@texoma.net
Home page http://home.texoma.net/~sitsinwest
----- Original Message -----
From: "Mark Hatch" <mhatch@ics.com>
To: <datsun-roadsters@autox.team.net>
Sent: Friday, April 26, 2002 6:05 AM
Subject: Recommendations for convertible top installation in Boston?
> Hi all,
>
> It's been awhile since my last post, but believe it or not I've been on
this
> list from the early 90's and the days of dialup Internet ;-)
>
> At one point, the conventional wisdom of the mailing list was to:
>
> 1. Go to a proffesional upholestry shop that specializes in installation
of
> convertible tops and have them do it.
> 2. Make sure that they install a Robbins (I might have misspelled this)
top.
> 3. Let the upholestry shop buy the top and pay the markup that they charge
> instead of going to one of the Roadster specialists.
>
> Is this still the advise of this mailing list?
>
> If so, does anybody have recommendations of a shop in the Boston area?
>
> Thanks
>
> Mark
>
> 1969 SRL-311
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|