Larry, I do not think the front wheel clearance will
be the problem, flared or not, the rear opening is a
bit restrictive however. I am using 280 Z wheels (the
5 spoke alloy that kind of looks like a 2 part wheel)
6"X 14" with 195/60X14's and it is extremely tight. I
had to move the body over about 1/8 inch to stop a rub
when I went over bumps.
Mike Harper
'66 1600
Charleston SC
--- "Dziuba, Larry" <LarryD@pengrowth.com> wrote:
> That's a good question. I have read all the recent
> dialogue too but it
> always seems to veer off towards modifications of
> all sorts. And I don't
> always understand the lingo. I would like to know
> this so I can add some
> nice Panasports for a basic 14 inch wheel. My
> roadster is a '68 based on
> the serial # and has the widest flares on the front
> fenders. Thanks in
> advance (I hope)! Larry.
>
> -----Original Message-----
> From: Mark Sedlack [mailto:msedlack@neo.rr.com]
> Sent: Thursday, August 02, 2001 10:12 AM
> To: Datsun Roadster Mailing List (E-mail)
> Subject: Wheels & tires
>
>
> I know this has probably been asked before ( ad
> nausem ), but listquest.com
> appears to be down, so I can't check the archives,
> and I couldn't find this
> info on any of the notable roadster web sites.
> Does anyone have a list or chart of wheel / tire
> combinations ( wheel size &
> offset or backspacing ) that will fit a Roadster
> without significant mods
> like flares, etc.)?
> TIA,
> Mark
> 66 1600
> 77 280Z
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
|