I don't mean to sound retarded, but wouldn't a heat shrink tubing prohibit
an accelerator or choke cable from sliding freely?
----- Original Message -----
From: Patrick J. Horne <horne@cs.utexas.edu>
To: Eric Armstrong <ericarm@cal.alumni.berkeley.edu>
Cc: datsun roadster list <datsun-roadsters@autox.team.net>
Sent: Sunday, July 15, 2001 2:06 PM
Subject: Re: cable housing
> Find some yellow heat shrink tubing that will fit over your
> cables.
>
> Peace,
> Pat
>
> - Support Habitat for Humanity, A "hand up", not a "hand out" -
>
> Pat Horne, Network Manager, Shop Supervisor, Future planner
> CS Dept, University of Texas, Austin, Tx. 78712 USA
> voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
>
> On Sat, 14 Jul 2001, Eric Armstrong wrote:
>
> > Hi -
> >
> > I'm doing a little detailing on my '66 1600. Anybody know where I can
> > source *yellow* throttle cable housing (and for that matter, choke,
heater
> > vent control cable housing). I found some yellow bicycle brake/shift
> > cable housing, but it's too thin. Throttle and choke cable housing
> > appears to be more heavy duty.
> >
> > any leads most appreciated. Thanks,
> >
> > -Eric
> >
> >
> > Eric Armstrong
> > ~~~~~~~~~~~~~~
> > e-mail: ericarm@alum.calberkeley.org
> > http://alum.calberkeley.org/~ericarm
|