Dean,
Often the MC as well as brake cylinders build up corrosion on the front
end of the bore. In the past I've sealed one fitting and used
compressed air in the other with the whole thing wrapped in a towel.
Watch out the piston will come out like a rocket!!!!! Someone in the
past has suggested using a grease gun so as to reduce the projectile
potential. As far as I know there are no retaining screws.
Dana
Datsundude@aol.com wrote:
>
> Hello folks,
>
> Does anyone know how to remove the front piston from a 1970 roadster M.C.
> There is no stop screw, all I see are 4 little indents in the back of the
> piston. The picture of a M.C. at the Rallye site shows a stop screw on the
> side of the cylinder. What do I have, its a 3/4'' bore M.C.
>
> Thanks for the info
>
> Dean
--
Dana Nojima, Ph.D.
Department of Urology
VA Medical Center - 112F
4150 Clement Street
San Francisco, CA 94121
phone: (415) 221-4810 x 2031
fax: (415) 750-6639
noji-1@pacbell.net
|