Try drilling a small hole and then using a slide hammer and metal tapping
screw.
Andy
----- Original Message -----
From: "Pam & Paul Bauman" <plhbauman@earthlink.net>
To: "Roadster List" <datsun-roadsters@autox.team.net>
Sent: Monday, August 14, 2000 10:09 PM
Subject: freeze plugs
> Had a freeze plug on the bottom of the intake manifold go bad. The
manifold
> appears to be an aluminum casting. Anyone have any luck pulling these bad
> boys out and replacing them with new? The diameter of the replacement
plugs
> you used would be helpful, but right now, I just need to know how to pop
> them out of the manifold without turning it into recycle bin fodder!
>
> Paul Bauman
> Westminster, CA
> 67 1600
> http://albums.photopoint.com/j/AlbumIndex?u=881168&a=6499541
>
>
|