-----Original Message-----
From: Thomas Walter <walter@omni.sps.mot.com>
To: HIGHKIX4@aol.com <HIGHKIX4@aol.com>; datsun-roadsters@autox.team.net
<datsun-roadsters@autox.team.net>
Date: Saturday, October 16, 1999 12:27 PM
Subject: Re: Seats, body plugs, paint booth, note to CDM
>
>Jim,
>
>On the seats:
>
>Up to, and including 67 model, NO seat back release.
>
>67.5 model seats: seat back release down near the floor (towards the door);
> optional headrest that BOLTED to the back of the seat.
>
>68 and later: seat back release is up high. Headrest (a common option),
> fitted into two holes on the TOP of the seats.
>
>Since you have had both seats redone, I would install the seat back
>release one with the release towards the door. At least you'll be able
>to reach it. Stiching was different on all three seats, but if you
>have a matching pair... should be fine.
>
>Cheers,
>
>Tom Walter '67 2000 w/ MGB-GT seats!!
>Austin, TX.
>
Tom.......
I have a pair of 68 - 69 seats with no holes for head rests. Question, when
were the headrests mandatory rather than optional?
Mike Clothier
Norco, Ca.
70 1600 (?year seats)
|