| To: | ERIC@chip.cba.ufl.edu |
|---|---|
| Subject: | Re: Clutch master cylinder (Spitfire) - need help! |
| From: | Mark J Bradakis <mjb@triumph.cs.utah.edu> |
| Date: | Tue, 24 Nov 92 21:27:26 -0700 |
What year is the car? If it has a later dual circuit master, then there is either a retaining pin or a tip valve holding in the back part of the plunger assembly. You need to undo the big hex at the front of the cylinder or pull out the pin, depending on design. mjb. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Clutch master cylinder (Spitfire) - need help!, Eric Olson |
|---|---|
| Next by Date: | Minis - Lotus/Series A, Thomas Cohen |
| Previous by Thread: | Clutch master cylinder (Spitfire) - need help!, Eric Olson |
| Next by Thread: | Minis - Lotus/Series A, Thomas Cohen |
| Indexes: | [Date] [Thread] [Top] [All Lists] |