ba-autox
[Top] [All Lists]

Re: 2002 SFR Autocross Schedule

To: Jerry Mouton <jerry@moutons.org>, Smokerbros@aol.com
Subject: Re: 2002 SFR Autocross Schedule
From: "Pat Kelly" <lollipop487@attbi.com>
Date: Sat, 22 Dec 2001 10:41:07 -0800
Hmmm, 100 mph is a bit high if you're thinking SCCA Solo 2, but for AAS
that's fine. I wonder if the rent has gone up? I've run many events at Cal
Expo, but that was before new asphalt. It's good site, even if the access 
roads are not used. There's plenty of parking on other lots nearby. In fact,
at one point, an event was run on a more hilly lot on the other side of the
grounds that was a lot of fun. There was an off-camber downhill turn that
really brought out the pucker factor. :)
--Pat K
----------
>From: "Jerry Mouton" <jerry@moutons.org>
>To: <Smokerbros@aol.com>
>Cc: "Bay_Area_Autocross_List" <ba-autox@autox.team.net>
>Subject: Re: 2002 SFR Autocross Schedule
>Date: Sat, Dec 22, 2001, 10:31 AM
>

>The Porsche Parade ran an autocross there in 2000.
>I was about 100 MPH at the end of each long arm
>straight!  Had a new Boxster roll at the end, but 
>course design could fix that.  Fast courses are definitely
>possible!  Very nice accommodations very nearby, too.
>
>Jerry
>
>Jerry Mouton        mailto:jerry@moutons.org    Laissez les bons temps rouler!
>
>----- Original Message ----- 
>From: <Smokerbros@aol.com>
>To: <jesvilla@gte.net>; <black94pgt@pacbell.net>
>Cc: <76067.1750@compuserve.com>; <ba-autox@autox.team.net>
>Sent: Saturday, December 22, 2001 9:33 AM
>Subject: Re: 2002 SFR Autocross Schedule
>
>
>> In a message dated 12/22/01 9:30:58 AM, jesvilla@gte.net writes:
>> 
>> << I have gotten positive feedback from
>> Cal Expo for events there. Newly paved Asphalt (so I hear), 350'X900'
>> plus use of access roads, some of the older(ahem) autocrossers will
>> remember the very exciting access roads at Cal Expo.  >>
>> 
>> Jesus-
>> 
>> Best of luck!  All autocrossing in Northern California would benefit from 
>> that!
>> 
>> Charlie

<Prev in Thread] Current Thread [Next in Thread>