Like the subject line reads, I need some 5/16" ID washers around .080-.085"
thick, and they need to be a pretty good grade of steel. Anyone know where
I can find such creatures?
AN washers come in .032" and .063" thicknesses. I would like something
about .080-.085" thick without having to "stack" them together. And
machining single washers from chromemoly tubing is out of the question. I
have already tried that. It took us about 90 minutes to make just one
washer. Each successive one would have taken another 10 minutes or so and I
need them in bunches.
As usual, thanks in advance.
Eric Linnhoff
www.geocities.com/eric10mm/KnuckleDragger
"Under certain circumstances, profanity provides a
relief denied even to prayer."
Mark Twain
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|