I take a piece of heavy welding rod and bend about the last 2 inches back on
itself (180 degree bend), then cut a 2" wide piece of grey (ultra fine)
ScotchBrite and wind it around the rod until it's a semi-tight/semi-loose
fit in the bore. Attach that to a low speed drill and you have an excellent
hone.
Carl
CSRG/HSR-West #247 series 1 Alpine
Lotus 61 formula Ford
Subject: Re: Plunger for SII Brake Master Clinder
> Tim Stiffy wrote:
> >
> > I'm going to rebuild both my clutch master cylinder and the slave unit.
> Tim,
> Don't use a brake hone on the aluminum masters. It will ruin them. You
> need to polish the bores with 600 sandpaper wrapped around a dowel rod.
> Jan
|