Jan- The bottom part of the ring came un-glued allowing the little magnets
to slide slightly below the pickup module. I'm going to put it back
together and try it tomorrow.
Cool Cat Eddie ,1 S3 GT,3 S4's, 2 S5's, 2 MK1 Tigers
Deep South Rep TE/AE
----- Original Message -----
From: <jeyerman@ix.netcom.com>
To: "Ed Esslinger" <eee1@snowhill.com>
Cc: <tigers@autox.team.net>; "alpines-list" <alpines@autox.team.net>
Sent: Sunday, November 05, 2000 10:30 PM
Subject: Re: Problem with my Ignitor
> The problem might be caused by the rotor pressing down too hard on the
plastic "ring". I noticed when I installed an ignitor in my Hillman that
the rotor didn't sit right-I filed/sanded about 1/8 inch off the bottom of
the rotor and then it all seemed to fit well.
>
> Jan
|