Lou;
First I'd heard you mention the rubber coupling... To me, nothing about
that rubber coupling is a "just undo." It was something of an effort to get
that coupling properly installed and the safety wires and ground straps
connected. The locking plate/clamp assembly at the firewall seems easier
than that but there may be a better way still....
Thanks,
Dave
On Thu, Oct 31, 2013 at 8:37 AM, <lfm614@aol.com> wrote:
> **
> Its been a while but going from memory I thought you could just undo it at
> the bottom rubber coupling.
>
> Lou
> 72 Pimento
> ------------------------------
> *From: * David Friedlander <forzion7@gmail.com>
> *Date: *Thu, 31 Oct 2013 08:33:17 -0400
> *To: *Jeff Fetner<FETNERJ001@hawaii.rr.com>
> *Cc: *<lfm614@aol.com>; TR-6 list<6pack@autox.team.net>
> *Subject: *Re: [6pack] Trafficator Clip
>
> To get the column to slide off the splined shaft at the bottom
> (steering rack connection point) it appears one also needs to
> take off the steering column locking plate and clamp at the
> firewall, thus allowing 'upward' movement of the column.
>
> Dave
>
>
> On Wed, Oct 30, 2013 at 10:57 PM, Jeff Fetner <FETNERJ001@hawaii.rr.com>wrote:
>
>> And I think there are 'pips' on the clip so it will only fit on the
>> upper column in one position (well, two, since I think it could be put on
>> 180 degrees to the other side).
>> Just like Lou says, everything has to be lined up for straight ahead and
>> the clip sitting at 9 O'clock. After wheels straight ahead, I had to align
>> the shaft via the splines at the box to get the clip bump at 9. Then got
>> the steering wheel spokes in a "T" alignment separately.
>>
>> Jeff
>> 74 TR6
>>
>> -----Original Message----- From: lfm614@aol.com
>> Sent: Wednesday, October 30, 2013 12:37 PM
>> To: TR-6 list
>>
>> Subject: Re: [6pack] Trafficator Clip
>>
>> -----Original Message-----
>> From: lfm614@aol.com
>> Date: Wed, 30 Oct 2013 20:06:11
>> To: David Friedlander<forzion7@gmail.com**>
>> Reply-To: lfm614@aol.com
>> Subject: Re: [6pack] Trafficator Clip
>>
>> 9oclock.
>>
>> To do this you will have the wheels straight then disconnect the steering
>> shaft at the box and line it up correctly using the splines and steering
>> wheel in the proper orientation.
>>
>> Be sure to push the switch in to make good contact with the clip humps
>> before tightening the screws.
>>
>> Lou
>> 72 Pimento
>> -----Original Message-----
>> From: David Friedlander <forzion7@gmail.com>
>> Sender: 6pack-bounces@autox.team.net
>> Date: Wed, 30 Oct 2013 15:35:47
>> To: 6-Pack<6pack@autox.team.net>
>> Subject: [6pack] Trafficator Clip
>>
>> Hey team!
>>
>> I have never quite had my turn signals cancel correctly and it occurs to
>> me
>> I need to
>> adjust the position of the trafficator clip on my upper steering column,
>> just below
>> the horn ring. Can someone tell me the proper position of the detent
>> "hump"
>> on the
>> trafficator clip should be?? Rifht now, mine is at about the 10 o'clock
>> position and
>> that's not right. Any help appreciated. Bentley's is not clear on the
>> subject).
>>
>> Thanks any and all!!
>>
>> Dave Friedlander
>> '74 Six
>>
>> ______________________________**__________
>>
>> 6pack@autox.team.net
>>
>> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe:
>> http://autox.team.net/mailman/**options/6pack/lfm614@aol.com<http://autox.team.net/mailman/options/6pack/lfm614@aol.com>
>>
>> ______________________________**__________
>>
>> 6pack@autox.team.net
>>
>> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe: http://autox.team.net/mailman/**options/6pack/fetnerj001@**
>> hawaii.rr.com<http://autox.team.net/mailman/options/6pack/fetnerj001@hawaii.rr.com>
>>
>>
>> ______________________________**__________
>>
>> 6pack@autox.team.net
>>
>> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe: http://autox.team.net/mailman/**
>> options/6pack/forzion7@gmail.**com<http://autox.team.net/mailman/options/6pack/forzion7@gmail.com>
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|