To get the column to slide off the splined shaft at the bottom
(steering rack connection point) it appears one also needs to
take off the steering column locking plate and clamp at the
firewall, thus allowing 'upward' movement of the column.
Dave
On Wed, Oct 30, 2013 at 10:57 PM, Jeff Fetner <FETNERJ001@hawaii.rr.com>wrote:
> And I think there are 'pips' on the clip so it will only fit on the upper
> column in one position (well, two, since I think it could be put on 180
> degrees to the other side).
> Just like Lou says, everything has to be lined up for straight ahead and
> the clip sitting at 9 O'clock. After wheels straight ahead, I had to align
> the shaft via the splines at the box to get the clip bump at 9. Then got
> the steering wheel spokes in a "T" alignment separately.
>
> Jeff
> 74 TR6
>
> -----Original Message----- From: lfm614@aol.com
> Sent: Wednesday, October 30, 2013 12:37 PM
> To: TR-6 list
>
> Subject: Re: [6pack] Trafficator Clip
>
> -----Original Message-----
> From: lfm614@aol.com
> Date: Wed, 30 Oct 2013 20:06:11
> To: David Friedlander<forzion7@gmail.com**>
> Reply-To: lfm614@aol.com
> Subject: Re: [6pack] Trafficator Clip
>
> 9oclock.
>
> To do this you will have the wheels straight then disconnect the steering
> shaft at the box and line it up correctly using the splines and steering
> wheel in the proper orientation.
>
> Be sure to push the switch in to make good contact with the clip humps
> before tightening the screws.
>
> Lou
> 72 Pimento
> -----Original Message-----
> From: David Friedlander <forzion7@gmail.com>
> Sender: 6pack-bounces@autox.team.net
> Date: Wed, 30 Oct 2013 15:35:47
> To: 6-Pack<6pack@autox.team.net>
> Subject: [6pack] Trafficator Clip
>
> Hey team!
>
> I have never quite had my turn signals cancel correctly and it occurs to me
> I need to
> adjust the position of the trafficator clip on my upper steering column,
> just below
> the horn ring. Can someone tell me the proper position of the detent "hump"
> on the
> trafficator clip should be?? Rifht now, mine is at about the 10 o'clock
> position and
> that's not right. Any help appreciated. Bentley's is not clear on the
> subject).
>
> Thanks any and all!!
>
> Dave Friedlander
> '74 Six
>
> ______________________________**__________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/**options/6pack/lfm614@aol.com<http://autox.team.net/mailman/options/6pack/lfm614@aol.com>
>
> ______________________________**__________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/**options/6pack/fetnerj001@**
> hawaii.rr.com<http://autox.team.net/mailman/options/6pack/fetnerj001@hawaii.rr.com>
>
>
> ______________________________**__________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/**options/6pack/forzion7@gmail.
> **com <http://autox.team.net/mailman/options/6pack/forzion7@gmail.com>
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|