Hi Bob,
Thanks for the info. This looks like something I don't really need to
worry about
(I'm good at worrying I guess).
I located the Comp Prep manual and indeed Kas' baffle design looks like
just what I was thinking of.
Also, I promise not to experience oil starvation near your home or
commute.... ;-)
Regards,
Cregg
At 02:00 PM 9/2/2008, Robert Lang wrote:
>On Tue, 2 Sep 2008, Cregg Cowan wrote:
>
>>Fellow Sufferers,
>
>Hi,
>
>I don't suffer with my TR6's... perhaps I'm on the wrong list?
>
>:-)
>
>>I'm replacing thrust washers and oil seals, etc. in a motor that I'll put
>>in my daily driver/beater (the rods and mains are Vandervell with only ~20K
>>miles on them).
>
>And....
>
>>I'm wondering if there's an easy design for a windage tray and/or oil
>>baffle --- my favorite roads are twisty I worry about oil starvation.
>>While I have the motor on the stand it would be simple to fab
>>something. If nothing else, a simple vertical baffle can be tack welded in
>>place.
>
>Two things - the Kastner Comp Prep has a cheap pattern for a baffle setup.
>With $5 worth of 3/16" mild steel, a welder, a grinder and a SAT
>afternoon, you can be in fat city.
>
>Second - please don't ever drive at/near my home or my commute route
>(north of Boston, MA)! If you are concerned about oil starvation, let me
>explain my comments. I drive a race car with sticky tires on various
>autcrosss lots from flat airports to hilly stadium lots. My car sees
>pretty big g-loads and lots of transitions. I have NEVER had an oil
>starvation problem in that car. I admit that I do have the Kastner baffles
>in the oilpan. Note however that I do not have the Kastner oil sump
>extension in there as I have very strong feelings about driving any car
>where the sump hangs down below the frame.
>
>But in all seriousness, you can pretty much toss your TR6 at will and as
>long as the oil level is adequate, I guarantee that oil starvation is not
>a problem assuming that the oiling system is working properly.
>
>>Suggestions anyone?
>
>GET "THE BOOK"
>
>If you have money to burn, there's an FOT project to supply real windage
>trays (with baffles and crank scraper) from Ishihara-Johnson (the name may
>be wrong, but they advertise on eBay). But one of those puppies is over
>$400 and def. NOT recommended for a street driven car (as the benefits are
>outweighed by possible maintenance factors.
>
>>Thanks,
>>Cregg Cowan
>
>
>regards,
>rml
>---------------------------------------------------------------------------
>Bob Lang NER/SCCA | This space for rent
>Solo Chair 2008 TR6 40 F Prepared | Triumph!
>Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
>---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|