6pack
[Top] [All Lists]

Re: [6pack] trailing arm studs

To: "Philip E. Barnes" <peb3@cornell.edu>, <6pack@autox.team.net>
Subject: Re: [6pack] trailing arm studs
From: "Navarrette, Vance" <vance.navarrette@intel.com>
Date: Mon, 5 May 2008 08:50:43 -0700
        Phil:

        No need to buy a special drill bit. I have a drill bit set that
goes in 1/64" (1/16 through 3/8) and I just use the closest undersize
drill that I have. Aluminum is so soft that the tap will remove any
excess metal for you. What I often find is that if I have pulled the
threads out and need to repair them, the stripped hole is so close to
the correct size that I can simply run the heli-coil tap in without
drilling at all.
        Yes, it is ghetto repair work at its finest, no I have not had
any problems with it.

        Vance


    Vance Navarrette
    Cogito Ergo Zoom
    I think, therefore I go fast

-----Original Message-----
From: 6pack-bounces+vance.navarrette=intel.com@autox.team.net
[mailto:6pack-bounces+vance.navarrette=intel.com@autox.team.net] On
Behalf Of Philip E. Barnes
Sent: Monday, May 05, 2008 6:23 AM
To: 6pack@autox.team.net
Subject: [6pack] trailing arm studs

What is the threading of the holes tapped in the trailing arm to
secure the hub? I can't recall if it's 1/4-20 or 1/4-28. I want to
put in Heli-coils, but I don't want to get the wrong bits.

TIA,
--
Phil Barnes (peb3@cornell.edu)
Keeneyville, PA
'71 TR6  CC61193L (31 year owner)
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>