On Mon, 5 May 2008, Philip E. Barnes wrote:
> What is the threading of the holes tapped in the trailing arm to
> secure the hub? I can't recall if it's 1/4-20 or 1/4-28. I want to
> put in Heli-coils, but I don't want to get the wrong bits.
Stock 5/16-24
You can convert to 5/16-18, but you have to buy new studs and you _may_
have to grind them down a bit to clear the hub flange. I've used studs
that are course threat on one end and fine on the other for this job.
Those are hardware store / auto parts counter common parts (the
course/fine combo studs)
> TIA,
> --
> Phil Barnes (peb3@cornell.edu)
> Keeneyville, PA
> '71 TR6 CC61193L (31 year owner)
Regards,
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|