Oops...sorry, should be 1/2"
Now, you got that article?
Toad
--- "Robert M. Lang" <lang@isis.mit.edu> wrote:
> On Wed, 8 Nov 2006, Todd Bermudez wrote:
>
> > Joe,
> >
> > Remove the reservoir & you'll see this 1/4" hex
> bolt
> > in there. Best bet is to go to a hardware store &
> get
> > the proper 1/4" allen head wrench. I've tried to
> use
> > a nut on then end of a bolt with little luck.
>
> 1/4"?
>
> Isn't it a 1/2"??
>
> All the ones that I've done have a 1/2" set screw. I
> even have a piece of
> 1/2" hex bar stock that I use for the job.
>
> I must have "special" units. :-)
>
> > Cheers,
> >
> > Todd Bermudez
> > CD198L
> > CF25768UO
>
> regards,
> rml
>
------------------------------------------------------------------------------
> Bob Lang Room N42-140Q |
> This space for rent
> Consultant MIT unix-linux-help |
> Voice:617-253-7438 FAX: 617-258-9535 |
> Cell: 339-927-4489
>
------------------------------------------------------------------------------
>
>
____________________________________________________________________________________
Sponsored Link
Mortgage rates near 39yr lows. $420k for $1,399/mo.
Calculate new payment!
http://www.LowerMyBills.com/lre
|