Bob---Once you get close, using Greg's measurements, you can find the
old tapped holes by inserting a straight pin. Keep poking around till
you find them. (No damage to the new carpets) Then use an ice pick or a
nail to enlarge the pin holes.
Dick
Bob wrote:
For a winter project, I recarpeted the interior of my '76 TR6. In my
haste to remove the old carpet, I forgot to measure the location of the
seat belt parking devices. Could someome provide a measurement to the
screws which secure the belt parking device? I would guess that a good
reference point would be where the reinforcing wedge meets the fuzzy
door seal. Thanks in acvance for your help, Bob
|