Because my transmission's plug was so rounded over
(and stuck), I ended up welding a large nut onto the
head in order to get a good enough grip on it to
remove it with a socket and breaker bar. If yours is
still square, there is a special wrench available with
a 7/16" square hole sold by someone that is on this
list. Much less likely to slip.
Jim Schlemm
--- Cary Henry <caryhenry@hotmail.com> wrote:
I tried
to remove the fill plug,
but to no avail. The best fit seemed to be a 7/16
wrench but it kept
slipping because the plug is in there so tight.
Does anyone have any ideas
on removing the plug before I just drill it out?
__________________________________
Yahoo! Mail - PC Magazine Editors' Choice 2005
|