| To: | "6 List" <6pack@autox.team.net>, |
|---|---|
| Subject: | TR6 soft top installation |
| From: | "Jim Davis" <jdavis344@bellsouth.net> |
| Date: | Sat, 1 Feb 2003 16:07:20 -0500 |
Some one had a link to the Buckeye TR website that had an article by Nelson Riedel. I deleted the message. Now I can't find the link on the Buckeye site. I don't think it is there, but the link I followed this morning was valid. Whomever sent the message with the link, please resend it. TIA, Jim Davis Fortson, GA CF38690UO CF37325U |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Machining head for compression ratio, Ted Schumacher |
|---|---|
| Next by Date: | Fwd: TR6 Top Installation, Jay Snable |
| Previous by Thread: | Machining head for compression ratio, Neil Wehmeyer |
| Next by Thread: | Re: TR6 soft top installation, cm.sherman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |