| To: | chad.jester@ae.ge.com (Jester, Chad (GEAE)) |
|---|---|
| Subject: | Re: Door Lock Installation - HELP!!! |
| From: | tr6taylor@webtv.net (Sally or Dick Taylor) |
| Date: | Fri, 17 Aug 2001 14:49:32 -0700 (PDT) |
Chad---There are at least two manufacturers of replacement door locks. (I'm looking now at one each) On one that has the twin "V" points it looks like they only give you about .010 for (door) sheet metal thickness for the spring clip to open. The other gives you about .060, and has a single point. This one should be enough, even with the gasket suppied. If you have the V point kind, it might be necessary to pry them open enough to grind in some clearance, pain that this might be. Dick T. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: shaved cylinder head question. 73 TR6, Sally or Dick Taylor |
|---|---|
| Next by Date: | header/manifold, Opntop |
| Previous by Thread: | Re: Door Lock Installation - HELP!!!, Nelson Riedel |
| Next by Thread: | shaved cylinder head question. 73 TR6, mitch |
| Indexes: | [Date] [Thread] [Top] [All Lists] |