<div style="color:black;font: 12pt Arial, Helvetica, sans-serif;">
<div> <font size="3">Perry, I would try swapping the plugs to different cylinders and see if the problem follows what currently is the #2 plug to whatever cylinder you put that plug in.</font><br>
</div>

<div> <br>
</div>

<div> <br>
</div>

<div style="font-family:arial,helvetica;font-size:10pt;color:black">-----Original Message-----<br>
From: Perry Hammock <perryfly@gmail.com><br>
To: triumphs@autox.team.net<br>
Sent: Mon, Dec 28, 2020 2:55 pm<br>
Subject: [TR] TR3 Question -<br>
<br>

<div dir="ltr">Was out of town for a couple months and my little TR3 was put to bed without any preparation (left town in kind of a hurry, and drive the car practically daily in decent weather.<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">When I got back, it wouldn’t start without starting fluid, and ran terribly, was rally hard to get off idle.  Needed choke to run.  Underivable.<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">So I went through what it could be - figured something on startup.  Put some fuel treatment in the gas - thinking it had lost oomph while sitting, but running was really bad.  Changed plugs, checked fuel pump, timing (have pertronix) etc.  seemed like cylinder 2 was not firing -<br>
</div>

<div dir="ltr">Plug was definitely not fouled or as dark as other plugs.  Checked wiring - switched plug wires, new red rotor, new distributor cap (I use the MG cap with push in connectors), then found that if I removed the plug wires one at a time, it would nearly die, except for number 2.<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">Checked valve lash and reset, tied again - checked compression - 133 - 137 across the board.  Got it running again, got better, then ran good enough to drive - went fine.<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">OK - So maybe bad gas. Would Jake sense that the fuel srtailizer and octane booster finally worked its way to the cars.  But, still, cylinder 2 doesn’t affect engine running as much if spark wire pulled.  Is this a function of the firing order?  I cant imagine what it could be - cant be carb - feeds number 1 as well.  Has big spark, as do all the plugs, and from the cap.<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">Any ideas?  Sorry for the length of this post and thanks in advance!<br>
</div>

<div dir="ltr"><br>
</div>

<div dir="ltr">Perry<br>
</div>

<div dir="ltr">1960 tr3a overdrive</div>
<br>
</div>
</div>