<html><head></head><body><div class="ydp89414078yahoo-style-wrap" style="font-family:Helvetica Neue, Helvetica, Arial, sans-serif;font-size:16px;"><div dir="ltr" data-setdir="false">Hi:</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false"> My 1966 TR4A had round motor mounts that i am replacing with rectangular mounts.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">the new mounts have a metal u-shaped cradle that covers 3 sides . the ends are open rubber. the remaining side is exposed rubber with a raised but embeded metal bar covered by the rubber near the surface and holding the bolt.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">which side goes up ? the moss and rimmer parts books show the the open rubber side with the "lump" facing up towards the engine. but a photo from moss shows the the opposite: the steel of the cradle contacts at the engine and the open/rubber side sits on the frame. </div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">given the above , the two mounting holes in the frame , and the off center bolt locations , i figure there are eight ways install these mounts ? even that ignores the washers.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">please help. fred</div></div></body></html>