<div dir="ltr"><div dir="ltr">On Thu, Jul 11, 2019 at 2:43 PM Johnnie Donnelly <<a href="mailto:johnniedonnelly@gmail.com">johnniedonnelly@gmail.com</a>> wrote:<br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr"><div style="font-size:small">Hi Folks, I'm replacing the steering rack boots with the rack in the car, but having trouble slipping the inner end of the boot over the rack. Yes, I know the right and left boot are different. I just to get the boot to "open" enough to slide in into place. Any tricks worth using?</div></div><a href="http://autox.team.net/mailman/options/triumphs/ahwahneetr@gmail.com" rel="noreferrer" target="_blank"></a></blockquote><div> </div><div>Here is a trick I used.  Photos are a rack boot for my VW Westy but I used the same technique on the TR4...</div><div><br></div><div>Find a bottle with a larger diameter than what you need and stretch/ease/force the boot onto it.  I had hot water in the bottle and also used a heat gun to warm the rubber:</div><div><br></div><div><div><img src="cid:ii_jxzgld7q0" alt="VW Rack Boot 1.JPG" style="margin-right: 0px;"><br></div></div><div><br></div><div>Look for a plastic spray can lid that is just slightly larger diameter than what the boot has to go over.  If a spray paint lid is too large. some products have slightly smaller lids.</div><div><br></div><div>Now the exciting move -- get the boot off the bottle and onto the plastic lid (open end of the lid down).  Tricky because the lid may want to collapse when the boot is only partially on.  Easier with 2 people - one to stretch the boot opening and another to maneuver the lid:</div><div><br></div><div><div><img src="cid:ii_jxzgpdt81" alt="VW Rack Boot 2.JPG" style="margin-right: 0px;"><br></div></div><div><br></div><div>Now you cut away the portion of the lid that is outside the boot leaving a ring of plastic perhaps a ¼" - ½" wide inside the boot.  That ring should be flimsy but in fact will hold the boot open as it is under even pressure all the way 'round.  Last time I did this I left a little tab of plastic sticking out from the ring to make the final step easier.</div><div><br></div><div><div><img src="cid:ii_jxzgt3hz2" alt="VW Rack Boot 3.JPG" style="margin-right: 0px;"><br></div></div><div><br></div><div>Try to make the ring thinner that what that pic shows.</div><div><br></div><div>Now the ring and boot will fit over the big end of the rack.  Once it is pressed home you pull out the ring a bit, cut it with a pair of heavy scissors and remove it completely.  If you are lucky the boot will come to rest right where you need it.</div><div><br></div><div>Good luck.</div><div><br></div><div>Geo</div></div></div>