<font color='black' size='2' face='arial'>
<div> <br>
</div>

<div> <font size="2">Thanks Randall.  You have always been a great source and I really appreciate it. </font><br>
</div>

<div> <br>
</div>

<div style="font-family:arial,helvetica;font-size:10pt;color:black">-----Original Message-----<br>
From: Randall <tr3driver@ca.rr.com><br>
To: davgil <davgil@aol.com><br>
Sent: Thu, Sep 20, 2018 10:52 am<br>
Subject: RE: [TR] ZS XD 175 carbs needle adjustment<br>
<br>
Probably not.  There is a retaining screw on the side, but it's supposed to<br>
be spring loaded so the needle carrier can still move for adjustment.  But<br>
the adjusting screw can get jammed in the full rich position.<br>
Unfortunately, the hex is brass and relatively easy to strip.  If that<br>
happens, or you can't get it apart, you may have to drill the screw out and<br>
replace it (possibly along with the needle carrier).<br>
<br>
Soaking in a good penetrating oil (like PB Blaster) might help, but you<br>
should probably replace the O-ring afterwards.<br>
<br>
There's a good article at<br>
<a href="http://www.buckeyetriumphs.org/technical/Carbs/CarbsII/CarbsII.htm" target="_blank">http://www.buckeyetriumphs.org/technical/Carbs/CarbsII/CarbsII.htm</a><br>
The section on the needle adjustment is near the end.<br>
<br>
-- Randall  <br>
<br>
> -----Original Message-----<br>
> From: Triumphs [<a href="mailto:triumphs-bounces@autox.team.net?">mailto:triumphs-bounces@autox.team.net</a>] On <br>
> Behalf Of <a href="mailto:davgil@aol.com">davgil@aol.com</a><br>
> Sent: Thursday, September 20, 2018 10:02 AM<br>
> To: <a href="mailto:triumphs@autox.team.net">triumphs@autox.team.net</a><br>
> Subject: [TR] ZS XD 175 carbs needle adjustment<br>
> <br>
> Good morning,<br>
> My 1976 TR6 is running rich on the front cylinders based on <br>
> the color of the plugs.  I was attempting to adjust the <br>
> needle using a carb adjustment tool that locks the upper part <br>
> and passes the wrench through to the adjustment.  The wrench <br>
> will seat in the adjuster, but will not move either way.  I <br>
> did not think that these had locking screws to prevent any <br>
> change.  I was reluctant to force the needle and wanted to <br>
> see if there is something I am missing here.  <br>
> <br>
> <br>
<br>
</div>
</font>