<html>
<head>
<meta http-equiv="content-type" content="text/html; charset=utf-8">
</head>
<body bgcolor="#FFFFFF" text="#000000">
<font face="Arial Black">A <font face="Arial Black">couple of
thoughts on your clutch issue.<br>
<br>
<font face="Arial Black">1. Is the slave cylinder installed w<font
face="Arial Black">ith the bleeder valve on top? The hose
and bleeder valve are interchangeable so you just need to
swap them if they are not in the correct orientation rather
than turn the slave over.<br>
<br>
<font face="Arial Black">2. If so you can try removing the
slave with the hose attached and then bleed with the c<font
face="Arial Black">ylinder pointing down wards so the
bleeder is absolutely at the highest point. Yes you
will have to remove the oil filter adapter but at this
point that seems pretty minor.<br>
<br>
<font face="Arial Black">3. I had a similar problem
with a TR4. The master cylinder sea<font face="Arial
Black">l was wor<font face="Arial Black">n and if
you <font face="Arial Black">pumped </font>the
pedal quickly it woul<font face="Arial Black">d
suck air in past the master cylinder seal on the
return stroke. The proper way to fix this is to
rebuild the master but if you return the pedal
slowly to the up position during bleeding you
can get the air out and get the car home.<br>
<br>
<font face="Arial Black">Edward Hamer<br>
<font face="Arial Black">Petaluma CA</font><br>
</font></font></font></font></font></font></font></font></font></font></font>
</body>
</html>