[TR] ref: Vacuum Advance of a delco remy
Q
HDRider570 at att.net
Mon Jan 11 14:13:26 MST 2021
The vernier knob is the adjustment knob and does not move under normal
circumstance. Vacuum is usually measured in inches of mercury not PSI
and yes negative 9 PSI at the diaphragm should move the vacuum advance
plate. If you remove the cap and apply the vacuum you should see the
points plate move. You should check that the rotor arm moves as well by
turning it by hand.
With a timing light installed you should see the mechanical advance move
as you go from idle to higher RPM's.
Edward Hamer
Petaluma CA
More information about the Triumphs
mailing list