[TR] Advice on high compression head

[Jerry Van Vlack]

TSI can make any length you want.

From: DAVID MASSEY 
Sent: Wednesday, April 7, 2021 5:39 PM
To: cliff_hansen at outlook.com ; triumphs at autox.team.net 
Subject: Re: [TR] Advice on high compression head

I went the band-aid route on my TR3 for the same reason.  But the right way is to get a machinist to shorten the pushrods.  BPNW sells short rods for the TR6/SC engine but at that time they didn't have any for the wet-sleeve engine.


Dave 




-----Original Message-----
From: Cliff Hansen <cliff_hansen at outlook.com>
To: list Triumph <triumphs at autox.team.net>
Sent: Wed, Apr 7, 2021 4:23 pm
Subject: [TR] Advice on high compression head


The telenovela “What’s going on with this 4A cylinder head” has developed a new plot twist.

The head, after cleanup, measures 3.21” from bottom to the surface for the valve cover gasket. Stock is 3.330 (if I got the number correctly). Some PO cut 0.11 off, because only 0.010” was removed in this round of clean up. Now I can see an explanation for the persistent pinging I’ve dealt with over the last few years (head has been milled so compression is high, material near intake valves has been thinned, increasing likelihood of hot spots – I’m getting this from Kastner’s preparation book), which I had thought was due to leaking intakes, carb shafts, or operating at higher altitude.

As is, I can’t use this head because there is not enough slack in the valve train to give 0.010” clearance on several valves. I didn’t notice before, but now that I am looking, all the valve adjusters were nearly backed out all the way.

Looking for advice from the list: is there any reasonable way to use this head?
- I’d prefer to reduce compression but don’t see any reasonable way to accomplish that. I called GasketWorks and he gently discouraged me from getting a custom thick head gasket, saying instead I’d be better off finding a head which had not been milled so much. 
- Shimming the rocker pedestals to get valve clearance feels like a bandaid which certainly won’t address the pinging (assuming that the pinging is a result of the shortened head).

Would appreciate any advice on the way forward.

Cliff

Sent from Mail for Windows 10

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/dave1massey@cs.com



--------------------------------------------------------------------------------
** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/jerryvv@roadrunner.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20210407/b126af6e/attachment.htm>