[TR] O2 Sensor on TR6

[Stan Foster]

I have a wide band o2 sensor in my TR6 and it was helpful in setting up the DCOE carbs on my modified engine. The electronics, Bosch sensor and gauge were from Innovate and there are connections for hooking up to a laptop. 

The main issue I had was it is very hard to drive and watch the o2 sensor and while you can log the data coming off the sensor you don't get the other critical data such as rpm, speed, gear etc. I did try adding more gizmos to capture more data but failed to get them to work (gizmo would not trigger off my 123Ignition distributor).

Stan

-----Original Message-----
From: Triumphs <triumphs-bounces at autox.team.net> On Behalf Of Jim Henningsen
Sent: Friday, July 17, 2020 1:44 PM
To: triumphs at autox.team.net
Subject: [TR] O2 Sensor on TR6

Anyone have experience with adding O2 sensor on a TR6?  I am working on installing street comp upgraded motor and have exhaust header going into 2
1/4 straight pipe with cherry bomb near rear.  Will have Triple ZS carb setup.  While everything is apart seems like a good time to install and O2 bung.  Just curious if folks who have done this found it helpful in tuning carbs.  Thanks Jim Henningsen Ocala, FL
61 TR3A
62 TR4
75 TR6
81 TR8

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/stan@redtr6.com