[TR] Crankshaft Thrust washers (aka bearing)

[Dave Connitt]

Hi Bob,
Using two .005” oversized thrust washers in your situation will result in .001” clearance. Use one standard and one .005 and that would get you down to .006. I think that is closer to the maximum tolerance though. It will be interesting to see what others think l
Dave Connitt 

Sent from my iPhone

> On Dec 4, 2020, at 4:24 PM, Bob Nogueira <nogera at hotmail.com> wrote:
> 
> Catologs show that thrust washers are available in Standard and .005 oversized.
> Since the washers act in both directions, front to back back to front, does a .005 set reduce total clearance .010?
> With standard size I currently have a bit more than .011 play. Will using a set of .005 washers, will the play be reduced to .006 or .001?
> Thank you 
> 
> 
> Bob Nogueira 
> ** triumphs at autox.team.net **
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/dconnitt@fuse.net