[TR] making the mating surface of an oil pan flat

[Chris Simo]

i used a hammer, drift and steel block as an anvil.  i have a nice round
drift the size of the washer and hammer on that.

Sent from my TRASH-80

On Mon, Jan 21, 2019, 2:07 AM Sujit Roy <triumphstag at gmail.com wrote:

>   The PO put gallons of sealer around the pan/ sump and over tightened all
> the bolts. They are all raises and .if  I put a flat rule between holes, I
> can notice at least 1 or more mm gap.
>
> I am thinking of using a nut and bolt with a few washers to hopefully make
> the bolts holes flat again. Are there any other good simpler ways to do
> this. I don't want to hammer them as I think I will do more damage.
>
> Sujit
>
> --
> Sujit Roy
> Cupertino, California
>
> https://triumphstagblog.wordpress.com/
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs
> http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/ccsimonsen@gmail.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20190121/fa3ff2a5/attachment.html>