[TR] making the mating surface of an oil pan flat
Sujit Roy
triumphstag at gmail.com
Sun Jan 20 23:46:38 MST 2019
The PO put gallons of sealer around the pan/ sump and over tightened all
the bolts. They are all raises and .if I put a flat rule between holes, I
can notice at least 1 or more mm gap.
I am thinking of using a nut and bolt with a few washers to hopefully make
the bolts holes flat again. Are there any other good simpler ways to do
this. I don't want to hammer them as I think I will do more damage.
Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20190120/3268585f/attachment.html>
More information about the Triumphs
mailing list