[TR] Stag fuel pump installation

Frank Magnusson fmags at cox.net
Thu Nov 22 11:20:39 MST 2018


Well, thats how it ended up going on.  Thanks for the pictures; I hadnt seen those before.  The key seems to be to orient the top banjo bolt so that the fuel line is riding against the lower banjo bolt.  The other edge rides against the egr box.  Wasn't as bad as I thought once I got some light on the subject.

The other thing that helps alot is to install the banjo bolts and the rubber fuel hose and clamps with the whole assembly on the bench, then install the whole thing in the car rather than trying to install the hoses and tighten the banjo bolts with it installed in the car.  Also helps to mark the banjo bolt orientation with the pump temp installed in the car, then tighten them on the bench.

Whole thing took less than an hour.  On to start bending copper fuel lines....

Frank

Sent from my iPad

On Nov 17, 2018, at 3:48 PM, Randall <TR3driver at ca.rr.com> wrote:

>> Wondering 
>> what the stock installation is suppossed to look like. 
> 
> I believe the top line is supposed to have a bend in it, and runs down
> rather than up.  It goes below the boot board, then around the front of the
> tank to the other side (LH) where it goes forward along with the vapor line.
> 
> The attached snippets are from the early Repair Operations Manual (in the
> brown cover).
> 
> -- Randall 
> 56 TR3 TS13571L once and future daily driver
> 71 Stag LE1473 - awaiting engine rebuild
> 71-2-3 Stag - awaiting gearbox rebuild 
> <Fuel Delivery and Evaporation Control system.jpg>
> <Fuel pump and filler tubes.jpg>



More information about the Triumphs mailing list