Q HDRider570 at att.net
Wed May 16 07:52:21 MDT 2018

When you turn the motor over on the starter the light should blink with 
each pulse of the ignition.  Once the engine is running it will be on 

Electronics usually work or fail and are not usually intermittent.  You 
should check that you have a full 12 volts at the power wire of the 
ignition module at all times.

Also did you reverse the wiring for the coil when you changed to 
negative ground?  The CB terminal should be connected to the power from 
the ignition switch.

Edward Hamer
Petaluma CA

More information about the Triumphs mailing list