[TR] 57 starter photo

Bob Labuz yellowtr at adelphia.net
Wed Jul 13 08:07:27 MDT 2016


Tom,

You are correct. But this will be a 2 man job! I did compress the large 
washer and it moves just enough I think to expose that small ring. Good 
news it the ring does move very easy so I hope I can get it off!

Thanks for all your help.

Bob

On 07/13/2016 09:54 AM, Tom Householder wrote:
> compress the remaining assembly   and find a wire retaining ring in 
> the groove under the shoulder on the shaft  that will come out.
>
> compressing the assembly left at this point can be hard but careful 
> not to mess up the armature
>
> This can hang up on account of wear but generally some wiggling and 
> soft hammer blow will help
>
>
> On Jul 13, 2016, at 9:40 AM, Bob Labuz wrote:
>
>> Here is a photo I took with my phone of the ring/washer in question 
>> that is preventing me from removing the rubber unit assembly. Again 
>> it is similar in size as the outside locating ring that was split 
>> covered by a washer in Randall's diagram but I see no split
>>
>> I hope it comes through.
>>
>> Thanks,
>>
>> Bob<starter-shaft-ring.jpg>
>
>



More information about the Triumphs mailing list