[TR] ZS Carb Question

David Porter frogeye at porterscustom.com
Thu Feb 25 15:18:36 MST 2016


..it depends on the vacuum connection. If Joe sent you 2 then it 
probably uses both...
DaveP

On 2/25/2016 2:38 PM, James Henningsen wrote:
>
> I am installing new carb kits on my Zenith Stromberg 175  carbs, 
> actually for my 73 Jag, but exact to my TR6.  When you install a new 
> valve in the by-pass valve, is there a gasket on both sides of the 
> valve assembly?  The valve assembly is made attached to a rubber 
> gasket.  The valve kit came from Joe Curto has two gaskets in addition 
> to the valve assembly.  When I disassembled mine, one had no gasket 
> and just the valve assembly between the halves, and the other had one 
> gasket and the valve assembly.  Since each valve assembly kit comes 
> with two gaskets, I am assuming you put one on each side of the valve 
> assembly and then reassemble the halves together.  Any thoughts out 
> there before I install back on the car?  Couldn’t find any info on the 
> instruction sheet included or the parts manual.
>
> Thanks in advance,
>
> Jim Henningsen
>
> Ocala FL
>
> 64 TR4
>
> 73 Jag E Type
>
> 75 TR6
>
> 76 Celica
>
>
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/frogeye@porterscustom.com

-- 
Dave Porter Porter Custom Bicycles 2909 Arno St. NE Albuquerque, NM 
87107 505-352-1378 Go HERE: my world www.porterbikes.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20160225/149a4f3c/attachment.html>


More information about the Triumphs mailing list