[TR] Media blasting
Wbeech@flash.net
wbeech at flash.net
Thu Nov 26 14:44:43 MST 2015
If you are sand blasting, then yes protect the bearing surface. I use the glass beads that are much less abrasive, still I wouldn't direct the stream's attention directly to that surface.
Bill
Sent from my VIC-64
On Nov 26, 2015, at 1:28 PM, Andrew Uprichard <auprichard at uprichard.net> wrote:
What is the combined wisdom of the list when it comes to blasting - in this case the wheel hub surface where the bearings sit? The hubs need to be blasted, but I have been asked if the bearing surfaces need to be protected or not. Any feedback would be great. Thank you and Happy Thanksgiving!
Andrew Uprichard
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20151126/ae5e2c07/attachment.html>
More information about the Triumphs
mailing list