[TR] Wing bead kit plastic protective coating.

[Wbeech@flash.net]

I have a set of the same beading from TRF, not yet installed.  Better go check
it out.  If anyone has the solution please post it to the full list.

Bill

Sent from mobile Bill

On Sep 9, 2014, at 1:43 PM, tom white <tswhitez123 at hotmail.com> wrote:

Hi List,

I bought a wing bead kit from TRF for my 1960 TR3A.  Today I unpacked one to
install on a rear fender.  The beads have all been covered with a black
plastic protective coating.  No problem just peel and strip, WRONG AND
IMPOSSIBLE.

I called TRF and their suggestion was use a hair dryer of low setting on my
heat gun to strip the plastic, WRONG AGAIN. I did manage to get the plastic
off of one small rear fender tail bead with ten minutes of high heat from the
heat gun.  The same approach did not proof effective on the larger rear
fender
bead.  I also attempted to remove the plastic with buffing and nylon brush
wheels on my Dremel.  The Dremel proved useless too.  I tired acetone to
soften the plastic with no success.

Does anyone have an effective way to remove the plastic coating from the
fender beads?  Pleas4e let me know if there is a good way to remove this
plastic.
Best regards,
Tom

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net