[TR] Fitting hood latch/spring
Pete Ryner
pryner at verizon.net
Wed May 21 05:41:30 MDT 2014
I recently purchased a hood latch/return spring on my TR3. I attempted to
install yesterday but it doesn't seem to fit correctly. The four holes line
up fine for the horizontal attaching pieces on the bottom of the support
piece on the rear of the front shroud. However, I can only get one side to
line up with the shroud support bolts. The other side is a good 1/2 inch
from the support. Is there supposed to be a spacer installed? With the
unit installed it seems to keep the hood about a quarter inch proud of the
shroud along the middle of the hood. The dzus fasteners fit fine though.
Any information/pictures would be appreciated.
TIA
Pete
More information about the Triumphs
mailing list