[TR] TR3 stanchions and plates

[Andrew Uprichard]

The thought of attaching that set-up over new paint sounds scary.  At least
with the dzus type, you were able to slide the stanchions over the plates....

Thanks for the feedback!

-----Original Message-----
From: Carl TR [mailto:cfmtr3a at verizon.net]
Sent: Friday, May 24, 2013 3:33 PM
To: triumphs at autox.team.net
Cc: wbeech at flash.net; auprichard at uprichard.net
Subject: Re: Re: [TR] TR3 stanchions and plates

TS81802 came with plates that were between the stanchions and body.  similar
to the Dzus ones but without the cut-out for the springythingamajig.  There
was one extra in the parts bin - can't remember if it is left or right side.
They do have only the two holes.

Carl
1961 TR3A - TS81802LO
mysite.verizon.net/cfmtr3a
Tampa, Florida


On 05/24/13, WBEECH wrote:

I don't have any plates for TCF2549, stanchions bolt directly to the body. I
imagine this was the brainchild of some Coventry cost-cutter.

Bill


Sent from my iPhone

On May 24, 2013, at 1:50 PM, "Andrew Uprichard" <auprichard at uprichard.net>
wrote:

> List:
>
>
>
> How are you expected to hold the stanchion plates in place for the
> later
> (non-dzus) windshields? The dzus plates have three holes for securing
> screws to the body, but the later ones have just two for the large
> bolts which go through the stanchions. Any help appreciated. Thanks!
>
> Andrew Uprichard