[TR] TR6 ZS won'y idle Update

[Ed Oot]

I took a look at the carbs that came out and noticed that the idle screws 
were down much further that I had tried.  In fact. they were down enough 
that the pin that the lever pushes against is totally depressed.  What is 
the purpose of that pin?  I don't see it in my books.  Anyway, I then set 
the screw down to approx. the same setting.  This pretty much bottomed out 
the adjustment (screw appears shorter than on old carbs). Started the car 
and it idles at 8 to 900 without the choke pulled at all. Is the most likely 
reason for this the cam?  (which was in the car when I got it)..I will check 
the valve lash as I did find the specs on it. Big difference from stock.  I 
show stock at .010 while this cam spec is .015 inlet, .017 exh.  This seem 
plausible?


----- Original Message ----- 
From: "Mark J Bradakis" <mark at bradakis.com>
To: <triumphs at autox.team.net>
Sent: Sunday, March 18, 2012 11:05 PM
Subject: Re: [TR] TR6 ZS won'y idle


> Jeff wrote:
>> On 3/18/2012 11:45 AM, Randall wrote:
>>> Did the rebuilder use Grose Jets?
>>
>> My TR6, which had sat for 5 years when I got it, has Grose Jets.  I 
>> pulled 'em out, gave 'em a  shot of carb cleaner, and put 'em back 
>> in...the car has run great for a year.
>>
>> Did I get the only set that works?
>>
>> Jeff Scarbrough
>> Corrosion Acres, Ga.
>>
>> ** triumphs at autox.team.net **
>
> When they work, they work very well.  When they get a speck of whatever in 
> them
> they don't work very well at all.
>
> mjb.
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/triumphs/eoot@citlink.net