[TR] Intake Manifold Bolt Issue

[wbeech at flash.net]

Heat it real good, then spray it with PB Blaster, it will suck it in.
Welding a nut on the end will give you a better handle to work from. 

-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Dave
Sent: Tuesday, June 05, 2012 5:20 PM
To: triumphs at autox.team.net
Subject: Re: [TR] Intake Manifold Bolt Issue

I had to use vice grips recently on a manifold bolt (after using a smoky
wrench)

-----Original Message-----
From: Andrew Uprichard
Sent: Tuesday, June 05, 2012 4:56 PM
To: 'Larry Brouder' ; triumphs at autox.team.net
Subject: Re: [TR] Intake Manifold Bolt Issue

Is this a case where you can put a nut on the bolt, weld it in place and
then remove by turning the nut?  Worked in the past with me for a head stud
that was locked in place.

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net