[TR] TR6 Diffy Axle Flange Removal

[Bob Labuz]

Gary,

I was able to remove both flanges by putting them in a large vice and 
the using my breaker bar on a large puller by hitting the breaker bar 
with a BFH. They both popped off after a few wacks with the hammer. But 
if that failed, I would have used my impact wrench on full on the puller.

Good luck!

Bob

On 08/01/2012 05:29 PM, Gary Klein wrote:
> Everyone,
>
> I want to replace the shaft seals to stop the leaks and am wondering whether
> there is there a trick to remove the axle mounting flanges on a TR6 diffy?
> I've tried a big puller but they won't budge and applying heat could damage
> the bearings, right?
>
> Thanks in advance,
>
> Gary