[TR] main/rod bearings

Frank Fisher yellowtr3 at yahoo.com
Fri Sep 17 16:01:01 MDT 2010


Gary
0.254mm is equal to 0.010 inches
frank
________________________________
From: Gary Nafziger <nafzigerg at yahoo.com>
To:
triumphs at autox.team.net
Sent: Fri, September 17, 2010 2:20:13 PM
Subject: [TR]
main/rod bearings

taking apart tr-3 motor.  found that big end rod bearings
are .010 over.  taking 

off the main bearing front and rear bearing/seal I
find no notation of  .010 but 

do find the number 0.254 MM  above it another
number that i think is a part 
number.

just curious.  I'm assuming that the
main bearings are standard even though 
there is not a "standard" marking on
the bearings.  surely they aren't 0.254 mm 
over?  Is it normal to go over on
the rod bearings and leave the main bearings 
standard?  


thanks

gary n.
_______________________________________________
Triumphs at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/triumphs/yellowtr3@yahoo.com


More information about the Triumphs mailing list