[TR] Wiper motor Gear needed

[stantr6 at comcast.net]

Bill, 
If nobody has one, suggest you spend some time at a junk lot - you may find a similar unit, even in a later model, that you can adapt. 
I have found quite a few items in two wrecked MGs that work in my TR6 - they both sourced many of their components from the same vendor. 
Stan 

----- Original Message ----- 
From: wbeech at flash.net 
To: british-cars at autox.team.net, Triumphs at autox.team.net 
Sent: Friday, February 5, 2010 10:23:56 PM GMT -05:00 US/Canada Eastern 
Subject: [TR] Wiper motor Gear needed 

Hello List, 

Just got my wiper motor all running fine only to find out the nylon gear 
that drives the cable is partially stripped. Works fine if the wiper are 
flipped back from the windshield but not too good when in the correct 
working position. 

Anybody got a good one of these gears that you would wish to sell? This 
model is the early TR3A, the gear wheel is about 2" in diameter, the numbers 
on the gearbox case is 75296d, this number "130" is stamped onto the gear 
wheel itself. 

Thanks, 
Bill 

Bill Beecher 
'58 TR-3A TS/30766 L (On the road in 2009!) 
"A Triumph is man's best friend, it always comes when it is called...of 
course, some times it is difficult to make it go" 

_______________________________________________ 

Support Team.Net http://www.team.net/donate.html 

Suggested annual donation $11.47 


You are subscribed as stantr6 at comcast.net 

Triumphs at autox.team.net 
http://autox.team.net/mailman/listinfo/triumphs 

http://www.team.net/archive