[TR] TR3 Thrust washer thickness

[Ed Poplawski]

I got info from TRF, 0.092" is also the STD nominal thickness for a TR3.
I'll maybe need to thin down a bit a 0.005" over to make up the
difference to the 0.004 ~ 0.006 spec from the 0.012 float there now. BTW, I
remeasured the ones I took out and they were also 0.092 (with one reading at
0.091").

Ed Hudson Valley NY

On Mon, Apr 19, 2010 at 12:13 PM, Tom Note <tom628 at verizon.net> wrote:

>  Ed:  I'm sorry, but re-reading your post I just realized you were
> referring to *TR3* thrust washers, and I mistakenly assumed it was for the
> TR6.
> Must have been tired, or dumber than usual. Please wait for input from
> someone familiar with TR3's.
>
> Sorry Ed.
>
> Tom
>
>  ----- Original Message -----
> *From:* popnglo at gmail.com
>   *To:* Tom Note <tom628 at verizon.net>
> *Sent:* Monday, April 19, 2010 7:32 AM
> *Subject:* Re: Re: [TR] TR3 Thrust washer thickness
>
> Thanks, much appreciated.
>
> Ed
>
> On Apr 18, 2010 11:54pm, Tom Note <tom628 at verizon.net> wrote:
> > Ed:  Standard size thrust washers should be 0.092" new.
>
> > Tom
> >
> >
> > Subject: [TR] TR3 Thrust washer thickness
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > Does anyone know the nominal thickness of the crankshaft thrush washer? I
>
> >
> >
> > removed both sides, and they measured ~0.086" each. The end float was
> >
> >
> > 0.012". I plan on replacing with an oversized (0.005) and a standard.
> >
> >
> > Copper showed on one side, grey on the other, for both washers.
> >
> >
> > Ed (Hudson Valley NY
> >
> >
> >
> >
> >
> > _______________________________________________
> >
> >
> > Triumphs at autox.team.net
> >
> >
> > Donate: http://www.team.net/donate.html
> >
> >
> > Suggested annual donation  $11.47
> >
> >
> > Archive: http://www.team.net/archive
> >
> >
> > Forums: http://www.team.net/forums
> >
> >
> > Unsubscribe:
> http://autox.team.net/mailman/options/triumphs/tom628@verizon.net