[TR] Pilot Bushing Size

[Frank Fisher]

Bob
if its for a TR3
then the crankshaft has a 1.000" diameter hole, and its
1.160 deep with a chamfer of about 0.100 deep.
i machined my bushing to 0.999"
outside diameter.
i think the nose of the input shaft is 0.500". but if you
really need that, id like to double check it later.
Frank Fisher
________________________________
From: "bob at texmog.com" <bob at texmog.com>
To:
Triumphs at autox.team.net
Sent: Mon, November 2, 2009 9:30:30 PM
Subject: [TR]
Pilot Bushing Size

I know that I read a post a couple of weeks ago with this
information but
now I can't find it ( the price one pays for spending too much
time reading
the posts in the achieves).

Anyway I need the dimensions of the
pilot bushing in the crankshaft. Both
the inside and outside dimensions would
be nice as well as the bore in the
crank. 

Thanks 

Bob     
_______________________________________________

Support Team.Net 
http://www.team.net/donate.html

This list supported in part by the Vintage
Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive